Translations:Getting Started/37/en

Back to Defaults on a Meteobridge PRO

Whenever you lost connectivity the red LED keeps blinking fast. To get out of this situation, wait until red LED is in fast blinking mode and then press the button behind the pinhole below the LEDs on the front with an unfolded paper clip or a needle. Having done that the Display will show you options to choose from. Each time you press the button the cursor moves to the next item. To activate an item you just have to wait until the progress bar on the right has been running out. These are the options to choose from:

• SHOW DETAILS does nothing special but shows MAC, IP, Gateway IP, power consumption and temperature/humidity in the Meteobridge.
• REBOOT LAN CLIENT reboots Meteobridge PRO as a client for your wired LAN. Meteobridge expects a DHCP server in the LAN (mostly your router) to provide IP, network mask, gateway IP and DNS IP. This is the default configuration Meteobridge is shipped with.
• REBOOT WIFI AP reboots Meteobridge PRO as a WiFi access point. When the reboot is done Meteobridge PRO will show the SSID on the display and will ask you to connect with your mobile device to this WLAN and to browse to 192.168.1.1 where you will find the network configuration page of Meteobridge pro. Being there you can do needed network settings of your Meteobridge PRO to have it operational. „WiFi access point“ setting is just a temporary measure to allow you to reach network configuration without having the Meteobridge PRO connected to a wired LAN.
• RESET PASSWORD resets Meteobridge PRO's HTTP (and SSH) password back to „Meteobridge“.
• FACTORY RESET deletes all individual settings and reboots the Meteobridge. Data stored on the internal USB storage (like logged historical data) will not be touched.